Table of Contents
Advertisement
Appendix C: Jumper
Settings
Password
If you forget the registered password, set jumper SW1 on the motherboard to clear the
password, then restart the server.
SW1-1ON
OFF
Hardware setup information
To return hardware setup information to the default settings, perform the following steps:
1
Set jumper SW1-2 on the motherboard to "Clear," then start the server.
SW1-2: ON
After the information is cleared, the following message appears":
[8150: NVRAM Cleared by
Jumper
2
Shut down the server, turn power off, then return jumper SW1-2 to "Protect."
Clears the password.
Protect
CMOS Clear
OFF
"Protect"
263
Advertisement
Table of Contents
