Table of Contents
Advertisement
Connecting Hardware Devices
CAUTION: To avoid damaging the CPU/heat sink assembly, never apply pressure to
the heat sink when installing the CPU module.
8
Reinstall the exhaust fan module. For instructions, see
redundant exhaust fan
9
Reinstall the access panel, reconnect all signal and power cables, then turn on the
server. For instructions, read steps 7 through 9 in
53.
10
Press the power button to turn on the server.
11
Follow the on-screen messages to confirm that the installed CPU module is
recognized. If the CPU module is properly recognized, the information on the CPU is
displayed on two lines.
The following sample screen shows a 1.13 GHz, dual-CPU configuration.
Phoenix BIOS 4.0 Release 6.0
Copyright 1985-2000 Phoenix Technologies Ltd.,
All Rights Reserved
TigerBird II Server BIOS-Version X.XX
BMC firmware Revision X.XX
CPU-2 Pentium (R) III Processor 1.13 GHZ
XXXK System RAM Passed
XXXM Extended RAM Passed
12
If the processing speeds do not match, the following error message will appear:
8181: Mismatch among Processors Detected
13
Perform CMOS Clear process per information provided in
settings
information, refer to
TECHNICAL NOTE: If the server is running Windows NT, you may need to reinstall
and configure Windows NT to support a dual-processor configuration. For more
information, refer to your operating system documentation.
on page 63.
on page 264. Then, reset the Toshiba Factory CMOS settings. For more
BIOS settings
Maintenance overview
on page 101.
CPU module
Removing and replacing the
on page
Preset jumper switch
73
Advertisement
Table of Contents
