Service Modes (For Facsimile) - Toshiba E-STUDIO190F Service Manual

5.2.

Service Modes (For Facsimile)

5.2.1. Fax Service Mode Procedure
1. To enter the Fax Service Mode
a. Press "FUNCTION" and then "7" keys.
b. Press "MONITOR" four times, then press "* (TONE)".
c. Enter the desired code number or press the "V", "/\" arrow keys.
2. To exit the Fax Service Mode
Press "STOP" key.
Note:
The following buttons provide these functions in the Service Mode:
"START": : The new setting value is stored in the machine.
"V" : Scroll the function parameter number down.
"/\ " : Scroll the function parameter number up.
5.2.2. FAX Service Mode Table
The following service modes are provided to assist you in setting operational functions of the unit and
determining the condition of the unit.
No. Service Mode
00 Not Used
01 Function Parameter Setting
02 RAM Edit Mode
03 Print Parameter List / Report
04 Modem Tests
05 Not Used
06 RAM Initialize
07 Not Used
08 Check & Call
09 System Maintenance
10 Firmware Version
Allows changes to the function parameters (the home
position, etc.).
Factory use only.
Prints the Function Parameter List, Page Memory Test, Printer
Report, All Document File, Protocol Trace and Toner Order
Form.
Generates various binary, tonal and DTMF signals, by the
modem.
Initialize RAM and restore the default value of the function
parameters.
Note: Turn the Power Switch to the OFF and back to the ON
position to enable the parameter settings.
Allows input of information for Service Alert Report,
Maintenance Alert Report and Toner Order Form.
Used for Firmware Update, Firmware Backup, Parameter
Restore, Parameter Backup, Transferring Firmware from the
PC to the Flash Card and Sending a Received File during a
fatal printer error.
Displays Firmware Version for SC, SC Boot, Panel, etc.
154
Description