Receiving Documents; Reception Modes - Toshiba e-STUDIO50F Operator's Manual

Receiving Documents

Reception Modes

You can select one of the four modes as shown below.
Conditions
You normally receive
only voice calls.
You receive both voice
and fax calls.
You normally receive
fax calls only.
You receive both voice
and fax calls and a
Telephone Answering
Machine (TAM) is
connected.
NOTE
58
Suggested Reception Mode
Telephone Mode
(IN Mode)
You can answer the incoming call via an External
Telephone (Optional). If you receive a fax calling
signal, simply press
(See page 59)
Fax / Tel Auto Switching Mode
(IN Mode)
Unit will answer
distinguishes whether it is voice or fax call. If it is a
fax call, the unit will receive automatically. If it is a
voice call, the unit will signal (ring) through the
speaker for your attention. (See page 60)
Fax Mode
(OUT Mode)
Unit will receive the document(s) automatically. All
incoming calls (including a voice call) are
answered by the fax machine. (See page 61)
TAM Interface Mode
(OUT Mode)
The TAM answers the incoming call. During that
time, the unit also monitors whether it is a voice
call, the TAM continues to operate. If it is a fax call,
the unit will automatically switch the line to the Fax
and begin receiving the document(s).
1. Depending on the model of the Telephone Answering Machine (TAM) that is connected, some
of the features may not be compatible with your fax machine operating in the TAM Interface
mode.
2. If you are using the "Distinctive Ring Service" provided by your local telephone company,
please note that the ring pattern for your fax number must match with the setting of Fax
Parameter No. 36 (RING PATTERN DETECT). (See page 36)
If the setting does not match with the ring pattern, your machine will not receive a document
automatically and the telephone will continue to ring.
Furthermore, if your TAM does not support the "Distinctive Ring Detector" service, it may not
function properly in TAM Interface.
to receive manually.
START
the incoming call
(See page 62)
Settings
1. Fax Parameter No. 15 set to
1: Tel
2. Press the IN/OUT button to
turn the lamp OFF.
RCV MODE=TEL
1. Fax Parameter No. 15 set to
2: Fax / Tel SW.
2. Press the IN/OUT button to
then
turn the lamp OFF.
RCV MODE=FAX/TEL
1. Fax Parameter No. 16 set to
1: Fax
2. Press the IN/OUT button to
turn the lamp ON.
RCV MODE=FAX
1. Fax Parameter No. 16 set to
2: TAM / Fax
2. Press the IN/OUT button to
turn the lamp ON.
RCV MODE=TAM/FAX