Table of Contents
Advertisement
4.5.4.
Transmission Problems
Does the ID display?
Does the Verification Stamp
operate?
Is the copy quality OK?
Any other problems?
START
No
Yes
No
Yes
No
Yes
Yes
No
END
1. No ID function at the remote unit.
2. The ID is not set for the remote unit.
1. Set "STAMP=ON"
2. Check the SDR PCB.
3. Replace the Stamp Solenoid.
4. Replace the SDR PCB.
Make a copy and refer to Sect. 4.4.
See Sect. 4.3. (Troubleshooting with the
Information Codes).
105
Advertisement
Table of Contents
Troubleshooting
