Table of Contents
Advertisement
-
When servicing the equipment with the power turned ON, be sure not to touch live sections and rotating/operat-
ing sections. Avoid exposing your eyes to laser beam.
-
Use designated jigs and tools.
-
Use recommended measuring instruments or equivalents.
-
Return the equipment to the original state and check the operation when the service is finished.
3) Important Service Parts for Safety
-
The breaker, door switch, fuse, thermostat, thermofuse, thermistor, batteries, IC-RAMs including lithium batter-
ies, etc. are particularly important for safety. Be sure to handle/install them properly. If these parts are short-cir-
cuited and their functions become ineffective, they may result in fatal accidents such as burnout. Do not allow a
short-circuit or do not use the parts not recommended by Toshiba TEC Corporation.
4) Cautionary Labels
-
During servicing, be sure to check the rating plate and cautionary labels such as "Unplug the power cable dur-
ing service", "CAUTION. HOT", "CAUTION. HIGH VOLTAGE", "CAUTION. LASER BEAM", etc. to see if there is
any dirt on their surface and if they are properly stuck to the equipment.
5) Disposal of the Equipment, Supplies, Packing Materials, Used Batteries and IC-RAMs
-
Regarding the recovery and disposal of the equipment, supplies, packing materials, used batteries and IC-
RAMs including lithium batteries, follow the relevant local regulations or rules.
Caution:
Dispose of used batteries and IC-RAMs including lithium batteries according to this manual.
Attention:
Se débarrasser de batteries et IC-RAMs usés y compris les batteries en lithium selon ce manuel.
Vorsicht:
Entsorgung der gebrauchten Batterien und IC-RAMs (inclusive der Lithium-Batterie) nach diesem Handbuch.
4
Advertisement
Table of Contents
Troubleshooting
