Toshiba E-STUDIO190F Service Manual page 239

3.1. Creating a Master Firmware SD Memory Card using a PC
1) Install the "SD Memory Card Firmware Writing Tool" to your PC.
The "SD Memory Card Firmware Writing Tool" is in the CD. Please refer to the Readme file for
additional details.
2) Preparing the Firmware Code
Double click the appropriate Destination Shortcut Batch File and copy the Firmware Code File on the
CD-ROM to the Firmware Data Folder in your PC. Note that the files in the Archive will be extracted
automatically into the designated folder when the Archived file (.exe) is Double-clicked.
Example:
From:
Destination Shortcut Batch File: D:(CD-ROM Drive) \ xFirmware \ USA.bat
Firmware Code File:
To:
Firmware Data Folder:
3) Preparing the Master Firmware SD Memory Card
1. Insert the SD Memory Card (32 MB to 512 MB) into the SD Memory Card Slot.
2. Perform the SD Memory Card Write Tool.
3. After all firmware codes are copied, remove the SD Memory Card from the Slot.
The SD Memory Card is now ready to use for firmware update.
3.2. Formatting the SD Memory Card
1. Turn the Power Switch on the back of the machine to the OFF position. (During a Lightning Storm,
to prevent electrocution disconnect the Telephone Line Cable first before unplugging the AC Power
Cord.)
2. Install the SD Memory Card into the machine.
3. Turn the Power Switch on the back of the machine to the ON position.
The machine goes to Self Test mode and return to standby.
4. Press "FUNCTION", "ORIGINAL SIZE" keys and then Key "3" on the keypad sequentially.
5. Perform the Service Mode F9-15 (SD Memory Card Format).
6. After the SD Memory Card is formatted, the machine goes to Self Test Mode and return to standby.
7. Turn the Power Switch on the back of the machine to the OFF position.
8. Remove the SD Memory Card from the machine.
UF-8000_xx_xxxxxx.exe
C:\ Pcc \ Fup \ Data
239