Installing The Handset Kit (Gj-1150) - Toshiba E-STUDIO190F Service Manual

8.6.

Installing the Handset Kit (GJ-1150)

8.6.1. Contents
Qty.
1
1
1
1
Note:
1. The part number(s) may differ depending on the Destination.
2. Refer to the Parts List.
8.6.2. Installation
CAUTION!
Turn the Power Switch on the Rear Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord.)
Description
Cradle Assembly
Handset
Handset Cord
Installation Instructions
(1) Hook the projections of the Cradle Assembly
into the holes on the Left Cover.
(2) Connect the Handset Cord to the Cradle
Assembly and the Handset as illustrated.
(3) Fasten the Cradle Assembly Cable onto the
Hooks on the Rear Cover as illustrated.
(4) Remove the Protective Tab covering the
HANDSET Jack on the Rear Cover.
(5) Connect the Cradle Assembly Cord.
(6) Plug the AC Power Cord and turn the Power
Switch on the Rear Side of the machine to the
ON position.
(7) Reconnect the Telephone Line Cable if it was
disconnected.
251
Remarks