Arming And Disarming Your System; Keypress Tamper; Arm Your System In Away Mode; Arm Your System In Stay Mode - Interlogix xgen Installation & Programming Manual

Arming and Disarming Your System

You may arm and disarm partitions from a NXG-1820 keypad.
Only users with an authorized user code (Level 2 user) will be allowed to use the
xGen alarm system. Users with no valid user code (Level 1 user) do not have
access as defined by EN 50131-3.

Keypress Tamper

The NXG-1820-EUR keypad will be locked in screensaver mode when unused
for a preset time.
A valid PIN is required to unlock the screen and access the system. Users can
set PIN codes between 4 and 8 digits in length.
When an incorrect PIN is entered ten times the keypad is locked for 90 seconds
and the screen will display a lock icon. During this time the keypad will not be
operational and PIN codes cannot be entered.
After the 90 seconds expires, if the first PIN attempt is incorrect the 90 second
timer will start again. If the PIN code is valid, then the counter will reset and a
further ten attempts can be accepted.
Note: EN 50131 Grade 2 required settings - There are no disallowed
account codes. 5 digits minimum to provide 10,000 possible combinations.

Arm Your System In Away Mode

Touch the Away or Away + button to arm your system in Away mode:
If your system has multi-Partition control enabled, the Away + button will be
displayed.
A valid PIN code will need to be entered to determine what permissions they
have, this includes which Partitions and at what time/day that user has access.

Arm Your System In Stay Mode

Touch the Stay or Stay + button to arm your system in Away mode:
If your system has multi-Partition control enabled, the Stay + button will be
displayed.
A valid PIN code will need to be entered to determine what permissions they
have, this includes which Partitions and at what time/day that user has access.
48 xGen Installation & Programming Guide