Interlogix xgen Installation & Programming Manual page 78

3. Select the options you want, the SIA/CID event code can be customized. See
the xGen Reference Guide for a table of codes.
4. Go to Zones.
5. Select a zone number you want to program.
6. Enter a name for the zone.
7. Select the zone type profile you just created.
8. Select the zone options profile you just created.
9. Select a Partition group for the zone. If you want a zone to be in its own
Partition then select a Partition group with only one Partition. To create a
zone in a common Partition, select a Partition group with multiple Partitions.
Alternatively come back to this step later.
10. For a standard installation set the schedule to a preset which is 24 hours
every day, holidays should NOT be ticked. This will enable the first zone
profile.
If you want the zone settings to change based on a schedule, then select the
first schedule here.
If no schedule is set in either the first or second zone profile then the zone will
be disabled.
11. If you are setting up a keyswitch zone then the user number field controls
which user profile will be used to arm/disarm that Partition. When this zone is
activated then it will report as this user number.
12. If you are programming a second zone profile, then go to that now and repeat
steps 4-7.
76 xGen Installation & Programming Guide