Table of Contents
Advertisement
Disarming your system
If the area you want to access is armed, you must first disarm the system before you can access the area without
setting off an alarm. The illuminated (red) area LEDs on the keypad indicates which areas are armed.
On entering the area, the system will allow a preset entry time to disarm the area before an alarm occurs.
If there is an alarm condition when you are disarming the system, the alarm is reset. You must then find out
what caused the alarm and fix it. See
the alarms that recently occurred.
You might not be able to disarm specific areas in the premises because:
•
Your keypad has been programmed to disarm only specific areas in the premises. Make sure you know
which keypad to use if there is more than one present in the premises.
•
Your PIN code has been programmed to disarm only specific areas of the premises. Make sure you
know which areas you can disarm.
Disarm the system
If there are no alarms in the area, the display must show:
To disarm the system, do the following:
1. Enter your PIN code.
2. Press OFF (Figure 1 ).
3. The result of step 3 depends on whether the system has been programmed to display a list of the areas
assigned to your PIN code.
4. When the disarming procedure has been successful the AL-1103 area LED goes off, and the AL111x
LED goes from red to green. When an area is armed its LED illuminates red.
Listing past alarm events
on page 21 for details on how to get a list of all
There Are No Alarms In This Area
Code:
13
Advertisement
Table of Contents
