Table of Contents
Advertisement
DISARMING THE SYSTEM
When you enter the protected area through one of the designated Entry/Exit doors, the
keypad control will sound a continuous tone for the duration of the entry delay time, or
until you enter a valid code. The away, stay and night keys will go off and the tone will
stop. The security system is now DISARMED. If a valid code is not entered before the
end of the entry delay, an alarm will occur. (NOTE: If the away, stay or night keys
are flashing during the entry delay, the alarm system has been activated in your
absence. Leave the building immediately and call your alarm company and/or the
police from a safe location.)
ABORT FEATURE (Optional, see page 1)
The abort light will flash during an abort delay time. If a code is entered while this light
is flashing, all abortable reports will stop the communication process. Entering a code
during or after an alarm report to the central station will cause the abort light to come
on. It will stay on until the central station has received the cancel report.
TURNING THE DOOR CHIME ON AND OFF
The door chime is turned on or off by pressing [7]-[1] while the system is in the
disarmed state. If the chime is "on", the chime light will be illuminated. If the chime is
"off", the chime light will be off. Each time [7]-[1] is pressed it will toggle the chime
feature on/off and produce a momentary ding-dong sound.
BYPASSING ZONES
If you wish to bypass one or more zones, it must be done while the system is in the
disarmed state.
Press [BYPASS].
1.
Enter user code, if required. The bypass key flashes.
2.
Enter the zone number you wish to bypass, i.e. press [4] for zone 4.
3.
4.
Press [BYPASS] again.
The corresponding zone light will illuminate indicating the zone has been
5.
bypassed. Repeat steps 3 and 4 for any other zone(s) that need to be bypassed.
Press [BYPASS] again -or- press [#] to exit the Bypass Mode. The bypass key
6.
will stop flashing upon exiting the Bypass Mode.
LED Keypad
Advertisement
Table of Contents
