Arming And Disarming - Interlogix Concord 4 User Manual

The dial abort feature is factory set to 30 seconds. Your installer can change this
setting from 15 to 45 seconds.
Remember that fire alarms cannot be aborted/canceled. Disarming a fire
Note:
alarm will only silence sirens, but the alarm is still reported. If an accidental fire
alarm sounds, follow the procedures of your central monitoring station to prevent
dispatching authorities.
To cancel a police (intrusion) or auxiliary alarm:
1. Press 1.
Touchpads display ENTER CODE.
2. Enter your access code.
Touchpads display date and time or programmed idle text. The system
sounds one long beep.
Programmed idle text typically identifies the property (for example, "The
Note:
Jones") and is programmed by your installer.
If you are using a touchtone phone, see "Touchtone phone" on page 52.

Arming and disarming

When arming the system, you are turning on intrusion detection. When disarming
the system, you are turning off intrusion detection. Since your security needs
may vary throughout the day, your system has three levels to meet these
different needs. By setting your system to a particular level, only those sensors
programmed to detect in that level will activate an alarm.
• Level 1 (off)
• Level 2 (stay)
• Level 3 (away)
No matter which level your system is set to, sensors programmed as
Note:
active 24 hours a day (smoke sensors, heat sensors, panic buttons, and
environmental sensors) continue to monitor for and report alarm conditions.
Level 1 (off)
Use Level 1to:
• Cancel an alarm and stop sirens.
• Disarm the system when entering the armed premises (through a designated
delay door). Entry delay beeps sound to remind you that the system is armed
and you must disarm it.
Concord 4 User Manual 11