Table of Contents
Advertisement
Redialing When the Line is Busy
There are two methods of redialing: Manual redialing and Automatic redialing. This
section explains these two methods.
Manual Redialing
Press Redial/Pause to dial the last number you dialed with the numeric buttons. (This
starts redialing regardless of whether automatic redialing is enabled.)
Canceling Manual Redialing
To cancel manual redialing, press Stop.
Automatic Redialing
What is Automatic Redialing?
When you are sending using memory sending and the other party's line is busy, the
unit waits the specified time and then dials the same number again. You can set the
copier/fax to redial several times if previous attempts fail because of a busy signal. This
feature is called Automatic redialing.
After the initial dial attempt, the copier/fax is factory-set to wait two minutes and then try
to dial again. If the second attempt fails because the line was busy, the copier/fax will
again wait for two minutes and make a final attempt to complete the call.*
Automatic redialing can be turned off and on. The number of redialing attempts and the
time interval between attempts can also be adjusted. (1 p. 7-11)
If all redialing attempts are unsuccessful, the copier/fax will cancel the transmission and
print an Error TX Report to remind you that the transmission was not completed. (1 p.
11-4)
When automatic redialing is in use, the LCD alternately displays AUTO REDIAL and the
transaction number (TX/RX NO.) while it is waiting to redial.
Canceling Automatic Redialing
Automatic redialing cannot be canceled with the Stop button while the unit is waiting to
redial.
Follow this procedure to cancel automatic redialing:
1
Wait until the copier/fax begins redialing.
* Even if the copier/fax is set to redial several times, it will redial only once if there is no tone or there is a
ring back tone during the first attempt.
7-10
Sending Faxes
DIALING
Chapter 7
Advertisement
Table of Contents
