Redialing When The Line Is Busy; Manual Redialing; Canceling Manual Redialing; Automatic Redialing - Canon JX510P User Manual

Hide thumbs Also See for JX510P:
Table of Contents

Advertisement

Redialing When the Line is Busy

There are two methods of redialing: manual redialing and automatic redialing. This section explains
these two methods.

Manual Redialing

Press [Redial] to dial the last number you dialed with the numeric buttons*. (This starts redialing
regardless of whether automatic redialing is enabled.)
*This setting is only available when you dialed with the numeric buttons.

Canceling Manual Redialing

To cancel manual redialing, press [Stop/Reset]. You may then need to press [Start/Copy] for a
few seconds to feed out the document. See "Jams in the ADF" on page 72.

Automatic Redialing

What is Automatic Redialing?

When you are sending a document and the receiving party's line is busy, the fax waits the
specified time and then dials the same number again. You can set the fax to redial several times
if previous attempts fail because of a busy signal.
Automatic redialing can be turned off and on. The number of redialing attempts and the time
interval between attempts can also be adjusted (see page 57).
If all redialing attempts are unsuccessful, the fax will cancel the transmission. You can set the fax
to print the ERROR TX REPORT to remind you that the transmission was not completed (see
page 56).
When automatic redialing is in use, the LCD displays <AUTO REDIAL> while it is waiting to
redial.

Canceling Automatic Redialing

1
Press [Stop/Reset].
Note
If you want to cancel a memory-sending transmission while the fax is waiting to redial, you will
have to delete the document from memory (see page 41).

Setting the Options for Automatic Redialing

You can set the following options for automatic redialing:
Whether or not the fax redials automatically.
The number of times the fax attempts to redial.
The time interval between redialing attempts.
1
Press [Menu].
2
Use [{] or [}] to select <DATA REGSTRATION>, then press [Start/Copy]. The
LCD displays <USER SETTINGS>.
3
Use [{] or [}] to select <TX SETTINGS>, then press [Start/Copy]. The LCD
displays <ECM TX>.
28
Sending Faxes

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fax-jx210Qt5-2227-v02Jx210p

Table of Contents