Table of Contents
Advertisement
Loading Paper in the Multi-Purpose Tray
Follow this procedure to load paper in the multi-purpose tray:
1
Make sure the paper thickness lever
inside the ADF (Automatic Document
Feeder) is set to p (left).
• For optimum printing results, always leave
the paper thickness lever set to p (left).
c
Do not set the paper thickness lever
while the copier/fax is printing since
this will cause problems.
2
Raise the paper rest until it stops q,
then move the paper guide to the left
to match the size of your paper w.
3
Prepare a stack of paper by fanning
the edge that will feed into the unit
first, and then tapping the stack on a
flat surface to even its edges.
4
Insert the stack into the multi-purpose
tray until it stops q, so that the right
edge of the stack is aligned with the
right side of the multi-purpose tray.
Slide the paper guide snugly against
the left edge of the stack w.
• The multi-purpose tray holds up to 100
sheets of 20 lb. (75 g/m
• Make sure the stack is below the paper limit
mark (P).
Chapter 2
2
) plain paper.
C
B
a
I n
r t
k
C
r i
B
d
l -
l a
g
2
e
M
c
1
k
a
J
d
a
e
p
a
in
n
2
2
PAPER LIMIT MARK
Setting Up
1
1
2-17
Advertisement
Table of Contents
