Interlogix TruVision 21 User Manual page 79

2. Enter the required settings:
Option
1. Working Mode
2. NIC Type
3. Internal NIC IPv4
Address
4. Bridge PoE
Camera Network
5. Enable DHCP
6. IPv4 Address
7. IPv4 Subnet Mask Enter the subnet mask for your network so the recorder will be recognized
TruVision NVR 21 (SP) User Manual
Description
Select from Multi-address, Load Balance, and Net Fault Tolerance. This
option is not available on the TVN 21S.
Network interface card (NIC) is a device used to connect the recorder to a
network. Select the NIC type used from the drop-down list.
This is only available for TVN 21S. Enter the internal NIC IPv4 address.
This is the IP address of the recorder's internal network managing only
the PoE port cameras. This is not the LAN IP address.
Default value is 192.168.254.1.
This is only available for TVN 21S. Check this box to enable the Bridge
PoE Camera Network.
Default value is Enable.
DHCP (Dynamic Host Configuration Protocol) is a protocol for assigning
an IP address dynamically to a device each time it connects to a network.
Check this box if you have a DHCP server running and want your recorder
to automatically obtain an IP address and other network settings from that
server. The DHCP server is typically available in your router.
Default value is Disable.
Enter the IP address for the recorder. This is the LAN IP address of the
recorder.
Default value is 192.168.1.82.
within the network.
Default value is 255.255.255.0.
Chapter 11: Network settings
73