Interlogix TruVision NVR 50 Quick Start Manual

TruVision NVR 50 Quick Start Guide
Content
Contact information 1
Package contents 1
Installation environment 1
Quick install 1
First-time use 1
TVN 50 front and back panels 2
Operating the NVR 50 4
Web browser control 4
Live view mode 4
Configuring the NVR 50 5
Specifications 6
Contact information 6

Contact information

For contact information, see our Web sites:
www.utcfireandsecurity.com, www.interlogix.com or
www.utcfssecurityproducts.eu.

Package contents

The TruVision NVR 50 (model TVN 50) is shipped with
the following items:
• IR (infrared) remote control
• Two AAA batteries for the remote control
• AC power cords (US, Europe, UK)
• USB mouse
• NVR
• CD with software and manuals
•
TruVision NVR 50 Quick Start Guide
• TruVision NVR 50 User Manual (on CD)

Installation environment

Refer to the user manual for detailed information, but
observe these important requirements:
• Place the unit in a secure location.
© 2013 UTC Fire & Security. All rights reserved.
• Ensure that the unit is in a well-ventilated area.
• Do not expose the unit to rain or moisture.

Quick install

Recommended steps for setting up the NVR:
1. Connect all the devices required to the back panel of
the NVR 50. See Figure 2 on page 3.
Basic connections:
Connect monitor A to the BNC, VGA or HDMI
output. Connect the mouse to the USB port in the
front panel.
Optional connections:
All the other connections shown are optional and
depend upon installation requirements.
2. Connect the power cord to the unit and turn on the
power.
3. Set up the unit with the required settings using the
setup Wizard.

First-time use

The NVR 50 has an express installation wizard that lets
you easily configure basic NVR settings when first used.
It configures all cameras simultaneously. The
configuration can then be customized as required.
By default, the setup wizard will start once the NVR has
loaded. The wizard walks you through some of the more
important settings of your NVR. Select the preferred
language for the system and then enter the administrator
password. The default admin password is 1234. It is
strongly recommended that this password is changed.
The wizard will then guide you through the menus to set
the time and date, network configuration, HDD
management, and recording configuration.
When all the required changes have been entered, click
to exit the wizard. The NVR 50 is now ready to
Finish
use. Recording starts automatically.
P/N 1072605• REV A • ISS 06FEB13