Mitsubishi FR - S500 Instruction Manual page 123

Changing example Deflecting the meter (analog indicator) to full-scale (5V) at the
POINT
The calibration parameters "C1" can be made to be ready by setting "1" (extended
function parameter valid) in Pr. 30 "extended function display selection".
Set the value of the calibration parameter C1 "AM terminal calibration".
1.
Confirm the RUN indication and operation
mode indication.
The inverter must be at a stop.
2.
Press the
MODE
parameter setting mode.
3.
Turn the setting dial
" " .
Pr. 30 must be set to "1".
(For details, refer to the instruction
manual (basic)).
4.
Press the
" " .
5.
Turn the setting dial
calibration parameter C1 "AM
terminal calibration" appears.
6.
Press the
7.
Press the
inverter. (The motor need not be
connected.)
8.
Turn the setting dial
adjust the indicator needle
to the desired position.
9.
Press the
Setting is complete.
REMARKS
Depending on the set value, it may take some for the needle to move.
If "1" is set in Pr. 30 "extended function display selection", the calibration parameter
C1 "AM terminal calibration" can also be set in the external operation mode.
When the FR-PU04 is used, make calibration with Pr. 901.
preset frequency of 60Hz (for frequency setting, refer to the
instruction manual (basic).)
Operation
key to choose the
to show
key to show
SET
until the
key to enable setting.
SET
key to start the
RUN
to
key.
SET
By turning the setting dial
Press the key to return to the
SET
Press the key twice to show the next parameter (
SET
MODE
SET
SET
RUN
+
-
SET
Flicker ... Parameter setting complete!!
, you can read another parameter.
indication (step 4).
114
Display
RUN
PU
EXT
The parameter
number read
previously
appears.
RUN
PU
EXT
Analog indicator
).