Adjusting Multifunction Switch F125 - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
– Push lever -3- onto selector shaft -4-.
– Use lever -3- to shift gearbox to "P" position, i.e. press lever
-3- back (opposite direction of travel) to stop.
– Now use lever -3- to shift gearbox to "N" position. To do this,
push lever -3- two detent positions forwards in direction of
travel.
– Place spring ring -2- and nut -1- on selector shaft -4-.
– Tighten nut -1- to 13 Nm.
– Check selector mechanism
3.3 Adjusting multifunction switch -F125-
Special tools and workshop equipment required
♦ Setting gauge -T10173-
– Move selector lever to position "N".
– Do not kink selector lever cable.
3.3.1 Adjustment prerequisites
• Selector lever cable is disconnected from selector shaft lever.
• Selector shaft is set to "N" position.
• Securing bolts for multifunction switch -F125- have been loos‐
ened.
• Selector shaft lever has been removed.
20
Rep. Gr.37 - Controls, housing
⇒ page 33 .