Removing And Installing Gearbox Input Speed Sender G182 - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
– Separate connectors -2- and -5-.
– If a connector is damaged, the wiring harness or the gearbox
input speed sender -G182- or the gearbox output speed send‐
er -G195- must be renewed.
– Unscrew bolt -6-.
– For reinstallation, make sure bracket is attached to gearbox
oil temperature sender -G93- -7-.
– Carefully pull gearbox oil temperature sender -G93- -7- out of
valve body together with bracket.
– Unhook wiring harness from bracket -8-.
– Pull connector -1- off gearbox connector.
– Unscrew bolt for 8-pin gearbox connector.
– Pull connector and wiring harness outwards out of gearbox
housing.
4.4.2 Installing
Install in the reverse order of removal, observing the following:
– Renew O-ring on connector.
– Push connector with new O-ring into gearbox to stop.
– Tighten bolt for 8-pin gearbox connector; torque specification
⇒ page 89 .
– Tighten bolt on bracket of gearbox oil temperature sender -
G93- , torque setting
– Install ATF strainer ⇒ page 85
– Install oil pan ⇒ page 82
4.5 Removing and installing gearbox input
speed sender -G182-
4.5.1 Removing
– Remove valve body
106
Rep. Gr.38 - Gears, control
⇒ page 89 .
.
.
⇒ page 91 .