Volkswagen Golf Variant 2007 Workshop Manual page 116

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
– Screw a self-tapping screw, approx. 4 mm in diameter, into
hole drilled in oil seal -arrow-.
Note
Do not screw in sheet metal screw too far to avoid damaging
bearing behind it.
– Pull out oil seal using puller -T10055- and adapter -T10055/2- .
– Remove cloth and carefully clean gearbox and drive shaft
aperture.
No iron chips must enter gearbox or drive shaft aperture; vacuum
up chips if necessary.
If only the sheet metal ring of seal could be pulled out, carefully
lever out rest of seal with a screwdriver.
1.1.2 Installing flange shaft oil seal
Install in the reverse order of removal, observing the following:
– Apply ATF to circumference and sealing lips of oil seal.
Installation position:
Open side of oil seal faces gearbox.
– Press oil seal in straight as far as possible by hand.
Left-hand side
– Drive seal -A- to stop with thrust piece -T10176- . Do not cant
oil seal in the process.
Right side
– Drive seal -A- to stop with thrust piece -T10177- . Do not cant
oil seal in the process.
– Install drive shaft ⇒ Rep. Gr. 40 ; Repairing drive shafts; Re‐
moving and installing drive shafts .
– Finally, check ATF level and top up
– Install noise insulation.
112
Rep. Gr.39 - Final drive - differential
⇒ page 77 .