Removing And Installing Selector Mechanism With Selector Lever Up To 02.2009; Removing And Installing Selector Lever Cable Up To 02.2009 - Volkswagen Golf Variant 2007 Workshop Manual

❑ Adjusting ⇒ page 30
9 - Hexagon nut with washer
❑ 8 Nm
❑ Qty. 4
4.2 Removing and installing selector mech‐
anism with selector lever up to 02.2009
Carry out procedure as follows:
Note
Following installation, selector lever cable must be checked for
ease of movement and be adjusted.
– Remove selector lever cable from gearbox
– Remove centre console ⇒ Rep. Gr. 68 ; Compartments, cov‐
ers and trims .
– Remove selector lever cable from gearbox
– Remove exhaust system below heat shield ⇒ Rep. Gr. 26 ;
Removing and installing parts of exhaust system .
– Remove heat shield beneath selector mechanism.
– Remove 4 nuts for selector mechanism "from above".
Torque setting for nuts: 8 Nm
– Take selector mechanism out downwards.
– Check selector lever cable after installing
4.3 Removing and installing selector lever
cable up to 02.2009
Carry out procedure as follows:
Note
Following installation, selector lever cable must be checked for
ease of movement and be adjusted.
Removing
– Move selector lever to position "S" position.
– In order to remove selector lever cable from gearbox, first re‐
lease cable -arrows 1- and then remove it from cable support
bracket -arrow 2-.
Note
Do not use any pliers, otherwise securing tabs on cable sup‐
♦
port bracket could break off.
♦ Do not bend or kink selector lever cable.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
⇒ page 23
⇒ page 23
⇒ page 30
.
.
.
4. Selector mechanism up to 02.2009
23