Volkswagen Golf Variant 2007 Workshop Manual page 100

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
– When removing valve body, secure damper piston -2- to pre‐
vent it from falling out or remove together with spring if nec‐
essary.
4.2.2 Installing
Carry out procedure as follows:
– Routing of wires must be noted precisely to prevent them from
being trapped when valve body is positioned.
– Route wiring harness -5- in specified recess in gearbox ac‐
cording to figure.
The distance -a- must be maintained to prevent wiring harness
-5- from coming into contact with planetary gearbox and thereby
becoming damaged during vehicle operation.
– Route wiring harnesses -1-, -3-, -4- and -5- over edge of the
gearbox according to figure.
– Secure wiring harnesses on gearbox with adhesive tape.
– Damper piston -2- must be installed in gearbox in illustrated
position.
– If damper piston -2- has been removed, it must be cleaned
together with spring and installed in accordance with
⇒ Item 29 (page 88)
– Coat damper piston -2- and mounting in gearbox with ATF.
– Insert spring in damper piston.
– Insert damper piston with spring into mounting in gearbox.
– To prevent damper piston from falling out, press it into gearbox
until valve body is positioned.
– Carefully put on valve body, without pressing on forcefully.
96
Rep. Gr.38 - Gears, control
and ⇒ Item 30 (page 88) .