Volkswagen Golf Variant 2007 Workshop Manual page 63

– In order to remove selector lever cable from gearbox, first re‐
lease cable -arrows 1- and then remove it from cable support
bracket -arrow 2-.
Note
Do not use any pliers, otherwise securing tabs on cable sup‐
♦
port bracket could break off.
Do not bend or kink selector lever cable.
♦
– Lever cable -1- off lever -3- using an open jaw spanner -2-.
– Tighten hose clamps up to Ø 25 mm -3094- on hoses and
remove hoses from ATF cooler.
– Disconnect electrical connections to gearbox and starter.
♦ Multifunction switch
♦ Starter motor
– Remove upper starter motor bolt.
– Remove plenum chamber cover ⇒ Rep. Gr. 50 ; Plenum
chamber cover; Removing and installing plenum chamber
cover .
– Set up support bracket -10 - 222 A- and support engine and
gearbox. Do not raise.
1 - -T40091/3-
2 - -10-222 A /31-1-
3 - -10-222 A /12-
4 - -10-222 A /3-
5 - -10-222 A /31-4-
6 - -10-222 A /31-3-
7 - -T40091/1-
8 - -10-222 A /18-
9 - -10-222 A /31-2-
– Remove upper engine/gearbox connecting bolts.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed automatic gearbox 09G - Edition 04.2010
7. Removing and installing gearbox, Jetta 2011 ▸
59