Media Feeder Motor Tray Lift Error Service Check; Sensor (Input) Never-Arriving Jam From Tray 1 Service Check - Lexmark MX81 series Service Manual

Media feeder motor tray lift error service check

Action
Step 1
Ensure the pick roller is properly installed.
Is the pick roller properly installed?
Step 2
Ensure the cable for socket "INDEX / PAP OUT/ PICK MTR" on the controller
board is properly connected.
Is the above connection properly connected?
Step 3
Reset the machine.
Does the error continue?
Step 4
Reset the machine.
Does the error continue?

Sensor (input) never-arriving jam from tray 1 service check

Action
Step 1
Check the media size setup and tray guides for media tray 1.
Does the media size, in use, match the size set for media tray 1?
Step 2
Check the media tray 1 for overfilling.
Is media tray 1 overfilled?
Step 3
Check the media condition in media tray 1.
Is any of the media in media tray 1 crumpled or damaged?
Step 4
Check the pick roller in the media tray being picked from.
Is the pick roller free of excess wear and contamination?
Yes
Go to step 2.
Go to step 3.
Replace the media
feeder. See
feeder removal" on
page
Go to step 4.
Replace the controller
board. See
board removal" on
page
Yes
Go to step 2.
Remove any excess
new media.
Replace the damaged
media with new.
Go to step 5.
Diagnostic information
86
No
Remove and reinstall
the pick roller. See
"Pick roller assembly
removal" on page
363.
Reseat the connection.
Problem solved.
"Media
379.
Problem solved.
"Controller
372.
No
Replace the media, or
change the media size
setup in media tray 1.
Go to step 3.
Go to step 4.
Clean or replace the
pick roller. See
roller assembly
removal" on page
363.
7463
"Pick