Sensor (Input) Late-Leaving Or Did-Not-Clear Jam Service Check - Lexmark MX81 series Service Manual

Action
Step 12
Perform a print test, and check the main motor assembly.
Is the media properly transported and able to reach the sensor (input)?
Step 13
Perform a print test.
Does the problem remain?

Sensor (input) late-leaving or did-not-clear jam service check

Action
Step 1
Check the media size setup and tray guides for all media trays.
Does the media size, in use, match the size set for all media trays?
Step 2
Check the media trays for overfilling.
Are any of the media trays overfilled?
Step 3
Check the media condition in all media trays.
Is any of the media in any of the media trays crumpled or damaged?
Step 4
Check media origination.
Did the media originate from the MPF?
Step 5
Check the MPF pick roll assembly.
Is the above component free of excess wear and contamination?
Step 6
Perform a MPF print test, and check the MPF pick solenoid for proper
operation.
Does the above component operate properly?
Step 7
Check the pick roller in the media tray being picked from.
Is the pick roller free of excess wear and contamination?
Yes
Go to step 13.
Contact the next
highest level of
technical support.
Yes
Go to step 2.
Remove any excess
new media.
Replace the damaged
media.
Go to step 5.
Go to step 6.
Go to
Go to step 8.
Diagnostic information
61
No
Replace the main drive
motor. See
motor removal" on
page 377.
Problem solved.
No
Replace the media, or
change the media size
setup.
Go to step 3.
Go to step 4.
Go to step
Clean or replace the
MPF pick roller. See
"MPF pick roller
removal" on page
326.
step 9. Replace the MPF pick
solenoid.
Clean or replace the
pick roller. See
roller assembly
removal" on page
363.
7463
"Main drive
7.
"Pick