Lexmark MX81 series Service Manual page 169

Error code Description
243.21 Media feeder motor stall in tray 3.
243.22 Media feeder motor pick motor under‑speed in tray
3.
243.24 Media feeder motor stalled on the last pick attempt
in tray 3.
243.32 Tray 3 not ready
243.33 The media tray was pulled during the media pick
process.
243.41 Media feeder motor stall in tray 3
243.42 Media feeder motor under‑speed in tray 3
243.43 Media feeder motor did not reach the required speed
243.44 Separator pass through motor stall in tray 3
243.45 Separator pass through motor under‑speed in tray 3
243.46 Separator pass through motor did not reach the
required speed.
Action
1
POR the printer.
2
Open the media trays and make sure there are
no obstructions on the media path.
3
Check the following:
•
•
•
4
If only one option is installed, re‑seat the option
tray. If there are multiple options installed, swap
the current option with another matching media
tray to determine the source of the error.
If the error persists, then perform the following
service checks:
•
•
1
POR the printer.
2
Open the media trays and make sure there are
no obstructions on the media path.
3
Check the following:
•
•
•
4
If only one option is installed, re‑seat the option
tray. If there are multiple options installed, swap
the current option with another matching media
tray to determine the source of the error.
If the error persists, then perform the following
service checks:
•
•
Diagnostic information
167
Make sure the size of the media loaded is
within specifications.
Make sure the tray guides are not set too
tight.
Make sure the tray is not overfilled.
For 250/550‑sheet trays—go to
sheet media tray option jam service check"
on page 174
For HCIT—go to "HCIT jam service check" on
page 176
Make sure the size of the media loaded is
within specifications.
Make sure the tray guides are not set too
tight.
Make sure the tray is not overfilled.
For 250/550‑sheet trays—go to
sheet media tray option jam service check"
on page 174
For HCIT—go to "HCIT jam service check" on
page 176
7463
"250/550-
"250/550-