Network Setup (Lan Cable Connection) - Kyocera TASKalfa 356ci Operation Manual

Installing and Setting up the Machine > Default Settings of the Machine

Network Setup (LAN Cable Connection)

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.
Set up TCP/IP (IPv4) to connect to the Windows network.
For other network settings, refer to the following:
Network (page 8-42)
NOTE
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and select [Login].
The factory default login user name and login password are set as shown below.
TASKalfa 356ci
TASKalfa 406ci
TCP/IP Settings
IPv4 setting
Set up TCP/IP (IPv4) to connect to the Windows network.
The default settings are as follows.
• TCP/IP: On
• DHCP: On
• Auto-IP: On
• IP Address: 0.0.0.0
• Subnet Mask: 0.0.0.0
• Default Gateway: 0.0.0.0
NOTE
Ask your network administrator for the IP address in advance, and have it ready when you configure this setting.
In the following cases, set the IP address of DNS server on the Command Center RX.
• When using the host name with "DHCP" setting set to "Off"
• When using the DNS server with IP address that is not assigned by DHCP automatically.
Setting the IP Address of the DNS Server, refer to the following:
Command Center RX User Guide
1
Model Name
3500
4000
Display the screen.
[System Menu] key > [System/Network] > "Network" [Next] > "TCP/IP Setting" [Next] >
"IPv4" [Change]
Login User Name
3500
4000
2-27
Login Password