Dsm Scan; Configuring Settings Before Sending; Executing Dsm Scan - Kyocera TASKalfa 356ci Operation Manual

Operation on the Machine > DSM Scan

DSM Scan

A scanned document can be automatically saved in any format or sent to any destination by reading a scan process
from Active Directory. This function only supports the computers installed Windows Server 2008 R2 or Windows Server
2012.

Configuring Settings before Sending

If you are performing DSM scan, check the items below.
• The machine is connected to an Active Directory on the network that the scan process can reference.
• "DSM Scan", "LDAP" and "HTTP" are set to [On] in Network.
Protocol Settings (page 8-44)
• "SSL" is set to [On] in Network.
Security Settings (page 8-45)
• [Network Authentication] is set in.
Enabling User Login Administration (page 9-3)
NOTE
If the Active Directory that the scan process can reference is not on the network authentication server, DSM must be
set in Command Center RX.
Command Center RX User Guide

Executing DSM Scan

1
2
3
[Home] key > [Send]
NOTE
Depending on the settings, the address book screen may appear. In this event, select
[Cancel] to display the screen for sending.
Place the originals.
Loading Originals (page 5-2)
Display the screen.
Select [WSD Scan/DSM Scan].
If WSD Scan is set to [Off] in the network settings, select [DSM Scan] and go to step 5.
WSD Scan (page 8-44)
5-33