Network Setup (Lan Cable Connection) - Kyocera TASKalfa 2550ci Operation Manual

Hide thumbs Also See for TASKalfa 2550ci:
Table of Contents

Advertisement

Network Setup (LAN Cable Connection)

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP
(IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows,
Macintosh, UNIX, NetWare and other platforms.
This section explains the TCP/IP (IPv4) Setup and AppleTalk Setup procedures. For other network settings,
refer to the Network on 9-94.
TCP/IP (IPv4) Setup...2-13
AppleTalk Setup...2-15
NOTE:
If user login administration is enabled, you can only change the settings by logging in with
administrator privileges. If user login administration is disabled, the user authentication screen appears.
Enter a login user name and password, and press [Login]. The login user name and login password are both
set to "2500" in the factory default state.
TCP/IP (IPv4) Setup (by Entering IP Addresses)
Set up TCP/IP (IPv4) to connect to the Windows network. Set the IP addresses, subnet masks, and gateway
addresses. The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off, Auto-IP: On".
NOTE:
Before configuring TCP/IP (IPv4) settings, ask your network administrator for permission to obtain
an IP address.
Use the procedure below.
System - IPv4
Set TCP/IP (IPv4).
* The setting will be changed after restarting the device or network.
IP Address
0.0.0.0
Subnet Mask
0.0.0.0
On
Default
0.0.0.0
Gateway
Off
Off
DHCP
Bonjour
Status
1
2
3
4
5
6
7
8
9
10
On
Auto-IP
11
Cancel
OK
12/12/2011 10:10
12
2-13
Press the System Menu key.
Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
Press [Change] of TCP/IP.
Press [On] and then press [OK].
Press [Change] of IPv4.
Press [DHCP].
Press [Off] of DHCP and then press [OK].
Press [Bonjour].
Press [Off] of Bonjour and then press [OK].
Press [IP Address] and enter the address using the
numeric keys.
Press [Subnet Mask] and enter the address using
the numeric keys.
Press [Default Gateway] and enter the address
using the numeric keys.
Preparation before Use
2

Advertisement

Table of Contents
loading

Table of Contents