Network Setup (Lan Cable Connection) - Kyocera FS-C2026MFP Operation Manual

Network Setup (LAN Cable Connection)

The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP
(IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows,
Macintosh, UNIX, NetWare and other platforms.
This section explains the TCP/IP (IPv4) Setup procedures. For other network settings, refer to Network
Setup on page 8-149.
NOTE:
After all network related settings have been done, turn the machine OFF and ON again. This is
mandatory to make the settings effective!
• TCP/IP (IPv4) Setup (when an IP address is automatically assigned) ...2-17
• TCP/IP (IPv4) Setup (by Entering IP Addresses) ...2-17
TCP/IP (IPv4) Setup (when an IP address is automatically assigned)
If an IP address will be automatically assigned, configure the settings below.
NOTE:
The [DHCP] and [Auto-IP] settings are enabled by default. Specify the settings below when Network
Setup on page 8-149 have been changed from their default state.
Use the procedure below to setup the TCP/IP (IPv4) setting.
Login User Name: L b
********************
Login Password:
Sys. Menu/Count.: a b
Report
1
Counter
2
System
3
*********************
[
1
[ Login ]
NOTE:
Appendix-7 for details on entering characters.
2
Exit ]
2-14
Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in.
Refer to Character Entry Method on
In the Sys. Menu/Count. menu, press the
key to select [System], and then press the OK key.
Preparation before Use
or