Maintenance - EverFocus EHN3160 Plus User Manual

7.8.4 Maintenance

【Maintenance Server】
Reboot: Click this button to reboot the unit without changing any of the settings. Use this function if
the unit is not behaving as expected.
Restore: Click this button to restart and reset most of the current settings to their factory default
values. The only settings that will not be changed to default are:
IP settings
•
DDNS settings
•
Default: The Default button should be used with caution. Pressing this button will return all of the
camera's settings, including the IP address, to the factory default values. The camera will then have
to be reconfigured.
【Save/Load Configuration Server】
Save: To make a backup file of the machine's current configurations, press Save to save all the
configurations to a config. file. This will enable the user to reload these configuration settings if the
settings are changed and there is unexpected behavior.
Load: To load a previously saved configuration, press the Browse button to locate the saved config.
file (see above) and then click the Load button. The system's settings will be restored to the saved
configuration.
64
EHN Plus Series