EverFocus EHN3160 Plus User Manual page 72

【Save/Load Video Configuration Server】
Save: To make a backup file of the machine's video configurations, press Save to save the video
configurations to a config. file. This will enable the user to reload these configuration settings if the
settings are changed and there is unexpected behavior.
Load: To load a previously saved video configuration, press the Browse button to locate the saved
config. file (see above) and then click the Load button. The system's settings will be restored to the
saved video configuration.
【Upgrade Firmware】Click the Browse button to find a previously prepared firmware upgrade file.
Click Upgrade to install the new firmware.
Note:
1. Do not disconnect power to the unit during the upgrade sequence. The unit will reboot
automatically after the upgrade has completed (1-5 minutes).
2. During the upgrade process, all event recording actions will be stopped. Event recording
actions will resume after the camera is rebooted.
65
EHN Plus Series