EverFocus EHN3160 Plus User Manual page 54

Noise Reduction Settings: This limits the amount of digital "video noise" that is usually found in
any video stream, and helps to reduce file size. The higher the level, the more the reduction.
For EHN3160 Plus / 3340 Plus:
Select ON / OFF to enable / disable the Noise Reduction function. Or select Auto to let the camera
automatically enable / disable the Noise Reduction function. Slide the Level bar to set up the level.
The higher the level, the more the reduction.
For EHN3260 Plus:
2D DNR: Select ON to enable the 2D DNR function.
3D DNR: Select ON to enable the 3D DNR function. You can further set up the following settings.
3D Start AGC: Set up the AGC level to automatically start the 3D NR function.

3D End AGC: Set up the AGC level to automatically stop the 3D NR function.

3D Level: Set up the 3D DNR level.

Smart NR: Select ON to enable the Smart NR function. The 3D NR function will be

automatically turned on when a motion event occurs.
White Balance Settings: Select the mode that delivers the best quality image for the camera's light
environment. There are five options: Auto, Manual, Indoor, Outdoor, One Push.
Auto: Select to let the camera automatically adjust the White Balance. In the Auto mode the

camera computes the white balance value output using color information from the entire
screen. It outputs the proper value using the color temperature radiating from a black subject
based on a range of value from 3000 to 7500K.
Manual: Select to adjust the Red and Blue values yourself in the fields below this field.

One Push: Select to enable the Push button

allow you to force the camera to readjust the white balance every time you push the Push
button. The lens will hold the same focal position until the next trigger command is received.
This function helps to prevent incorrect focusing in dark environments. This function is only
available for EHN3160 Plus / 3260 Plus.
Day/Night Settings:
Auto: Select to let the camera automatically switch to Night mode (black and white) when the

light levels fall to a specified level, and back to Day mode (color) when the light levels rise to a
specified level.
Day: Select to keep the camera in Day mode (color), even in nighttime.

Night: Select to keep the camera in Night mode (black and white), even in daytime.

next to the Mode drop‐down field. This will
47
EHN Plus Series