Ip Address Filter - EverFocus EHN3160 Plus User Manual

7.6.2 IP Address Filter

Use this page to specify IP addresses that are not allowed to access this camera. By default, any IP
address can access the camera.
Note: The Allowed List addresses only become relevant when the Denied List contains a
network or range, and the supervisor wants to allow one or more IP addresses within that
excluded range or network. In such a scenario, the user would enter the excluded range or
network in the Denied List, and enter the exceptions in the Allowed List.
To set up the IP Address Filter:
1. Select Denied List. Click the Add button, the following dialog box appears.
2. Select an IP type from the IP Type drop-down list.
3. Select a network rule from the Rule drop-down list, type the IP address and click OK.
Single: Type a single IP address in the IP Address field below.
Network: Type the IP address and subnet mask in the field below.
Range: Type a range for the IP addresses.
4. If you have set up an IP range in Step 3, you can optionally set up the Allowed List to allow one
or more IP addresses within the setup IP range to access the IP camera.
5. Click Apply.
55
EHN Plus Series