EverFocus EHN3160 Plus User Manual page 64

Enter Event Name: Type an event name.
Event Triggered by: Select an event or alarm type for the to-be-specified-below reaction/s.
Alarm Input: Select this if you want a reaction trigger coming from any external, connected sensor
to activate a to-be-specified-below reaction/s via the camera system. Make sure that a suitable
device is actually connected to the alarm input relay.
Manual Trigger: Select this option if you want to manually trigger the alarm by clicking the Trigger
Event button on the Live View Page.
Motion Detection: Select this option if you want motion in a specified part of the camera's viewing
rectangle (the screen image) to trigger the to-be-specified-below reaction/s.
Tampering Detection: Select this option if you want the camera's tampering detection sensor to
trigger the to-be-specified-below reaction/s.
Schedule Recording:
the recording schedule (the Settings > Event > Schedule page) to activate this event. In this
scenario, a preconfigured event reaction like a log entry will list the start and end times of each
period. Actual recording will only be triggered if the event is preconfigured to do so.
Enable This Event: Select to activate the event.

Enable Re-trigger: Click to set a minimum time after the event is triggered before the event

can be triggered again.
Enable Pre-trigger Buffer: Click if you want the Event reaction (as selected in the "Notification

Over" field below) to be the activation of the video recording function, and if you want the
recording to include the video feed from the time period (configurable on the previous "Event
Settings" page) just before the Event trigger occurred.
Enable Post-trigger Buffer: Click if you want the Event reaction (as selected in the Notification

Over field) to be the activation of the video recording function, and if you want the recording
to include the video feed from a time period (configurable on the Event Settings page) just
after the Event trigger occurred.
Motion Area: Select a setup motion detection area from the drop down list. Note this function

only becomes relevant after the Motion Detection areas have been set up (see 7.7.2 Motion
Detection).
Notification Over: Select the desired notification types form the following items.
Log: Click if you want the camera to list the event's details in its log if the event is triggered.

Trigger Alarm Output: Click if you want the camera to relay the event reaction to a device

attached to the alarm relay output wire and then set up the alarm output duration time.
Select this option if you want the Schedule Recording periods configured in
57
EHN Plus Series