Ez.hd series 720p analog high definition true day/night outdoor ir bullet camera (17 pages)
Summary of Contents for EverFocus Value IP Series
Page 1
The images may vary depending on the product and software version. Information contained in this document is subject to change without notice. EverFocus Taiwan: 2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw...
Page 2
1. Physical Description EHN Series SD Card Slot on EHN 2MP/5MP Series EZN Series No. Item Name Descriptions Light Sensor Detects lights. IR LEDs for infrared illumination in night vision IR LEDs applications. Lens Camera lens. Micro SD Card Slot Insert a micro SD card.
Page 3
2. Contact the shipper if any items appear to have been damaged in the shipping process. Optional Accessory You can go to the product page on EverFocus’ website to check the related optional accessories. www.everfocus.com.tw...
Page 4
2. Cables The cables provide connections for network, BNC video output, power, audio input / output and alarm input / output. A Reset Button Cable is also provided. Please be noted that microphones / speakers with a (built-in) amplifier and external power supply are required.
Page 5
Reset Button The Reset Button can be used to restore the camera to factory default. When the camera is powered up, press the Reset Button about 8 seconds to reboot the camera. 3. Installation 3.1 EHN Series 1. Stick the supplied Mounting Sticker on the surface to mark the 4 screw positions.
Page 6
3. Optionally insert a micro SD card into the card slot (please refer to 1. Physical Description). 4. Adjust the pan / tilt / rotate angles of the camera. 5. Connect the camera to power. You can either connect the camera to a 12VDC power source or to a PoE switch using the PoE cable.
Page 7
7. Before screwing back the camera cover, remove the 3 old desiccant bags from the inside of Camera Cover and replace them with the supplied Desiccant Bag. Screw the camera cover back to the camera. Remove the 3 desiccant bags Stick the supplied desiccant bag Note: Please screw back the Camera Cover immediately...
Page 8
3. Adjust the pan/tilt/rotate angles of the camera by loosen the Pan/Tilt/Rotate screws using the supplied Hexagon Wrench. Rotate Screws (both sides) Tilt Screw Pan Screw 4. Connect the camera to power. You can either connect the camera to a 12VDC power source or to a PoE switch using the PoE cable.