EverFocus EHN3160 Plus User Manual page 65

Send Mail Notification: Click if you want the camera to send an Event notification email to the

email address entered in the Set SMTP Server(email) field of the Network > SMTP/FTP page, if
the Event occurs (see 7.3.3 SMTP / FTP).
Upload to FTP: Click if you want the camera to upload recorded footage to the FTP server

entered in the Set SMTP Server(email) field of the Network > SMTP/FTP page, if the Event
occurs (see 7.3.3 SMTP / FTP).
Record to SD Card: Click if you want the camera to start recording its video feed (when the

event occurs) on an on-camera SD Card (if such a card has been inserted).
Note: The recording will only be as long as the combined Pre- and Post-trigger Buffers, so
make sure you enable at least one of these buffers, especially the Post-trigger Buffer.
Record to PC: Check this box if you want the camera to start recording its video feed (when

the event occurs) on the same folder on the same PC as configured on the User Config > User
Config page (if such a folder has been enabled and configured).
Note: The recording will only be as long as the combined Pre- and Post-trigger Buffers (and
for as long as the event trigger is happening – e.g. a motion is detected), so make sure you
enable at least one of these buffers, especially the Post-trigger Buffer.
Network Alarm: Check this box if you want the camera to send a network alarm signal (when

the event occurs) to the CMS servers configured on the Network > Network Alarm page (see
7.3.6 Network Alarm).
Click OK to save all settings, or click Cancel to cancel.
【Pre/Post Trigger Settings】
Pre-trigger Buffer: Select the duration for the buffer. This will determine the amount of footage
(length of time) before the event trigger moment that will be included in an event-triggered video
recording, if that buffer and video recording has been enabled in the Event Configuration Window.
Post-trigger Buffer: Select the duration for the buffer. This will determine the amount of footage
(length of time) after the event trigger moment that will be included in an event-triggered video
recording, if that buffer and video recording has been enabled in the Event Configuration Window.
Click Apply to save all settings, or click Reset to cancel.
58
EHN Plus Series