Safety Notice
‐These limits are designed to provide reasonable protection. This equipment generates, uses and can
radiated radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: ‐Reorient or
relocate the receiving antenna.
‐Increase these separations between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
The changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
To reduce risk of fire or electric shock, do not expose this appliance to rain or moisture.
Do not attempt to disassemble the appliance. To prevent electric shock, do not remove screws or
covers. There are no user‐serviceable parts inside. Contact qualified service personnel for maintenance.
Handle the appliance with care. Do not strike or shake, as this may damage the appliance.
Do not use strong or abrasive detergents when cleaning the appliance body. Use a dry cloth to
clean the appliance when it is dirty. When the dirt is hard to remove, use a mild detergent and wipe
gently.
Do not operate the appliance beyond its specified temperature, humidity or power source ratings.
Do not use the appliance in an extreme environment where high temperature or high humidity exists.
The input power source for this appliance is DC 12V & PoE. Use the appliance at a temperature between
‐40°C ~ 55°C / ‐40°F ~ 131°F (DC 12V) / ‐20°C ~ 55°C / ‐4°F ~ 131°F (PoE) and humidity between 0% ~
90%.
Use only the recommended power supplies. Power supplies must comply with the requirement of
the latest version of IEC60950‐1. Substitutions may damage the unit or cause a fire or shock hazard.
ii