Conducting A Flue Gas Test - Buderus Logano plus GB312 Installation Manual

7.10.1 Conducting a flue gas test

The button is used by the heating engineer for the
flue gas test.
The control system runs the heating at a raised flow tem-
perature for 30 minutes. During the flue gas test, the dec-
imal point on the status display lights up.
V Press and hold the
button until the decimal point
on the status display lights up (at least 2 seconds).
V Conduct the flue gas test.
V Cancel the flue gas test and press the
again.
7.10.2 Opening the Service menu and viewing
monitor data on the RC35
A PC running the Buderus Logamatic ECO-
Soft 4000/EMS software together with a ser-
vice key can also be used as a monitoring de-
vice. Please contact Buderus for more
detailed information.
V Simultaneously press the
open the SERVICE MENU.
V Turn the rotary selector
select Diagnosis (indicated by
V Press the
button to open the SERVICE/DIAG-
NOSIS menu.
V Turn the rotary selector
select Monitor reading (indicated by
V Press the
button to open the DIAGNOSIS/
MONITOR READING menu.
V Turn the rotary selector
select Boiler/Burner (indicated by
V Press the
button to open the BOILER/BURNER
menu.
The monitor readings are displayed as a list, i.e. turning
the selector scrolls down to more readings.
These menus enable you to read off the current boiler out-
put (set/actual) and the flame ionization current.
Logano plus GB312 - Technical specifications are subject to change without prior notice
button
+ + buttons to
counter-clockwise to
).
counter-clockwise to
).
counter-clockwise to
).
Recommissioning the heating system
110
100 120
90 130
Eco 140
Aut
Fig. 43 Starting the flue gas test
SERVICE MENU
quick operation
settings
B
diagnosis
servicing
SERVICE|DIAGNOSIS
function test
B
monitor reading
diagnosis
servicing
DIAGNOSIS|MON.READING
B
Boiler/Burner
domestic hot water
heating circuit 1
bus users
7
130
110
150
90
170
190
Aut
7 747 010 720-39.1RS
47