Installation; Mount The Module In The Enclosure; Mount And Wire The Tamper Switch (Optional); Wire To The Control Panel - Bosch B426 Installation And Operation Manual

10 en | Installation
4

Installation

After you set the address switch for the proper address, install the module in the enclosure
and then wire the module to the control panel and to the Ethernet connection.
4.1

Mount the module in the enclosure

Mount the B426 into the enclosure's 3-hole mounting pattern using the supplied mounting
screws and mounting bracket.
You must mount the module in the control panel enclosure or in a UL listed enclosure (for
example, the D8103 Universal Enclosure).
All communicators shall be housed in tampered enclosures, compliant with the following
clauses within Standard CAN/ULC-S304-06: 5.2.6; 5.2.9; 5.2.10 and 5.2.15.
Figure 4.1: Mounting the module
Callout ᅳ Description
1 ᅳ B426 with mounting bracket installed
2 ᅳ Enclosure
3 ᅳ Mounting screws (3)
4.2

Mount and wire the tamper switch (optional)

You can connect an enclosure door tamper switch for one module in an enclosure.
Installing the optional tamper switch for use with a B426:
1.
2.
4.3

Wire to the control panel

When you wire a B426 to an SDI or SDI2 control panel, you can use either the module's
terminal strip labeled R, Y, G, B (PWR, A, B, COM) or the module's interconnect wiring
connectors (wire included). The figure below indicates the location of both the terminal strip
and the interconnect wiring connectors on the module.
2013.08 | 02 | F.01U.281.208
1
Mount the EZTS Cover and Wall Tamper Switch (P/N: F01U009269) into the enclosure's
tamper switch mounting location. For complete instructions, refer to the Cover and Wall
Tamper Switch (ICP- EZTS) Installation Guide (P/N: F01U003734).
Plug the tamper switch wire onto the module's tamper switch connector. For the tamper
switch connector location, refer to B426 module overview, page 8.
Installation and Operation Guide (UL)
2
3
Conettix Ethernet Communication
Module
Bosch Security Systems, Inc.