Table of Contents
Advertisement
Replacing the cooling fan
Tools you need to complete this task:
v
Screws removed during this task:
To replace the cooling fan:
1
2
3
4
5
6
7
8
www.gateway.com
Flat-blade driver
Phillips #0 screwdriver
1 black 2.5*3.0 (DVD
drive)
3 black 2.5*3.0 (Palm
rest-DVD drive bay)
3 black 2.5*6.0 (Palm
rest-top)
Complete the steps in
"Preparing the convertible notebook" on page
Remove the memory bay cover by following the steps in
modules" on page
6.
Disconnect the wireless antenna wires by following the steps in
wireless card" on page
10.
Remove the DVD drive by following the steps in
Remove the hard drive by following the steps in
Remove the palm rest by following the steps in
Remove the system board by following the steps in
Turn the system board over so the bottom is facing up.
- OR -
2 black 2.5*3.0 (hard
drive)
3 black 2.5*2.2 (Palm
rest-hard drive bay)
3 black 2.5*4.5 (System
board)
"Adding or replacing memory
"Replacing the DVD drive" on page
"Replacing the hard drive" on page
"Replacing the palm rest" on page
"Replacing the system board" on page
Scribe or non-marring tool
2 black 2.0*6.0 (Palm
rest-bottom)
7 black 2.5*4.5 (Palm
rest-bottom)
2 black 2.0*3.0 (cooling
fan)
5.
"Replacing the IEEE 802.11
14.
17.
25.
39
35.
Advertisement
Table of Contents
