Table of Contents
Advertisement
12
Carefully open the LCD panel, then remove the two front LCD hinge screws.
Screw
13
Lift the old LCD assembly off of the convertible notebook.
14
Place the new LCD assembly on the convertible notebook. Make sure that the antenna wires
and LCD cable are routed between the front hinge screw posts.
15
Replace the screws removed in
16
Carefully close the LCD panel, then replace the screws removed in
17
Open the LCD panel, then replace the grounding screw removed in
18
Feed the antenna wires into the wireless bay.
19
Replace any tape that held the antenna wires and LCD cable.
20
Replace the system board by following the steps in
21
Replace the palm rest by following the steps in
22
Replace the hinge cover by following the steps in
23
Replace the hard drive by following the steps in
24
Replace the DVD drive by following the steps in
25
Reconnect the antenna wires to the wireless card by following the steps in
IEEE 802.11 wireless card" on page
26
Replace the memory bay cover by following the steps in
modules" on page
6.
www.gateway.com
Screw
Step
12.
10.
Step
11.
Step
10.
"Replacing the system board" on page
"Replacing the palm rest" on page
"Replacing the hinge cover" on page
"Replacing the hard drive" on page
"Replacing the DVD drive" on page
"Adding or replacing memory
35.
25.
23.
17.
14.
"Replacing the
53
Advertisement
Table of Contents
