Table of Contents
Advertisement
18
19
20
21
22
23
24
25
26
27
28
29
30
58
Replacing Convertible Notebook Components
Lay the black bracket on the fingerprint reader, then replace the two screws removed in
Step
14.
Make sure the brown fingerprint reader cable connector clip is in the raised position, then
insert the cable into the connector and lower the clip onto the cable.
Important
The cable is correctly oriented if it is not twisted.
Press the two halves of the LCD panel front and back together in several places until they
click in place. You should find no loose spots or spots where the two halves do not meet.
Replace the eight LCD panel assembly screws removed in
Replace the eight rubber inserts removed in
Replace the LCD assembly by following the steps in
Replace the system board by following the steps in
Replace the palm rest by following the steps in
Replace the hinge cover by following the steps in
Replace the hard drive by following the steps in
Replace the DVD drive by following the steps in
Reconnect the antenna wires to the wireless card by following the steps in
IEEE 802.11 wireless card" on page
Replace the memory bay cover by following the steps in
modules" on page
6.
Step
Step
10.
"Replacing the LCD assembly" on page
"Replacing the system board" on page
"Replacing the palm rest" on page
"Replacing the hinge cover" on page
"Replacing the hard drive" on page
"Replacing the DVD drive" on page
10.
"Adding or replacing memory
11.
51.
35.
25.
23.
17.
14.
"Replacing the
Advertisement
Table of Contents
