Table of Contents
Advertisement
7
8
9
10
11
12
13
14
15
30
Replacing Convertible Notebook Components
Disconnect the Bluetooth cable from the Bluetooth module.
Lift the right end of the old Bluetooth module, then slide the module out of the rubber holder.
Insert the left end of the new Bluetooth module under the flap in the rubber holder, then
press the right end down. The notch in the right end of the module should fit around the
pin located in the holder.
Connect the Bluetooth cable to the Bluetooth module.
Replace the palm rest by following the steps in
Replace the hard drive by following the steps in
Replace the DVD drive by following the steps in
Replace the wireless bay cover by following the steps in
card" on page
10.
Replace the memory bay cover by following the steps in
modules" on page
6.
Connector
"Replacing the palm rest" on page
"Replacing the hard drive" on page
"Replacing the DVD drive" on page
"Replacing the IEEE 802.11 wireless
"Adding or replacing memory
25.
17.
14.
Advertisement
Table of Contents
