ViewSonic SC-T46 User Manual page 78

2. Click drop-down menus, tick/untick checkboxes, or move sliders to choose desired settings. Refer to the
following table for a description of each setting item.
Keyboard
Item
Use Custom Keyboard Settings
Keyboard Layout
Keyboard Type
Enable NumLock on Boot
Show Blinking
Cursor
Blink Delay
Repeat Speed
Type
Settings
Repeat Delay
TIP
• Hang your mouse over the Up/Down arrow to quickly scroll up/down the Keyboard
Layout list.
• To fine-tune a setting value, click its slider, and then use the Right/Left key to
increase/decrease the value by 1 or the Page Up/Page Down key to increase/
decrease by 10.
3. Click Save to apply.
Check/Uncheck to enable/disable the use of custom keyboard settings.
NOTE: You are allowed to set the keyboard layout and type only when this
setting is enabled.
Click the drop-down menu to select the desired keyboard layout.
Click the drop-down menu to select the desired keyboard type.
Check/Uncheck to enable/disable the NumLock key after system startup.
Check/Uncheck to show/hide the Blink Delay slider.
Move the slider to select the blink delay between each occurrence of cursor.
Move the slider to select the character repeat rate when a key is held down.
Move the slider to select the character repeat delay between its each occurrence.
Down arrow
67
Configuring Client Settings
Configuring User Interface Settings
Description
Up arrow
67