ViewSonic SC-T46 User Manual page 188

Common Settings
Item
Non-Interactive Mode
Autostart When Startup
On Application Exit
Description
Select Yes or No to allow or disallow the Non-Interactive mode. The default is to
use the Non-Interactive mode.
Option Description
The Non-Interactive mode is used. Users are not allowed to
Yes re-select different settings if the settings have been specified
in View connection settings.
The Interactive mode is used. Users are allowed to
No re-select different settings even if the settings have been
specified in View connection settings.
Select whether to open a VMware View or Horizon View session automatically or
not when your SC-T46 is started up (Autostart mode).
NOTE: There are three similar but different modes for your SC-T46 and only one
mode will take effect if all are enabled. Three modes and the order of
priority are listed as follows:
No. Mode Description
The client will start up directly with the desired
1 Appliance VMware View or Horizon View session and turn off
after existing the session.
The client will start up directly with the desired
VMware View or Horizon View session and perform
the configured action after existing the session.
Available actions include:
2 Autostart
The default. The client will enter ViewSonic Quick
3 Quick Connection
Connection screen after system startup.
NOTE: To use the Autostart mode, ensure that the Appliance mode is disabled.
Select what to do when a VMware View or Horizon View session is ended.
Four options are available: Do Nothing, Restart Application, Reboot,
and Shutdown.
Option Description
Do Nothing Returns to the local desktop.
Restart Application Opens a VMware View or Horizon View session again.
Reboot Restarts your thin client.
Shutdown Turns off your thin client.
177
Configuring Client Settings
Configuring Service Access Settings
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
177