ViewSonic SC-T46 User Manual page 23

Setting Up Your SC-T46
12
Positioning Your SC-T46
Step 5: Mount Your SC-T46
To mount your SC-T46 on the back of a monitor, please do the following:
Step 2
1. Refer to
• You will need two (2) screws of type
• You will need two (2) screws of type
2. Place your SC-T46 on a flat surface with the VESA mount hole side upward.
3. Refer to Step 2
on your SC-T46 such that the bracket projects out and is closer to the rear panel than the front one as shown
below, and then secure the bracket to your SC-T46 with two (2) screws of type
4. Align the mount holes on the bracket with the mount holes on the back of the monitor, and then secure the
bracket to the monitor with two (2) screws of type
of the monitor and the rear panel of your SC-T46 is facing rightward as shown below.
Step 4
and to prepare required screws for mounting your SC-T46.
2
1
to choose two of the four VESA mount holes on the bracket to align with two mount holes
to secure the bracket to your SC-T46.
2
or to secure the bracket to the monitor.
2 1
or . Ensure that your SC-T46 is located in the center
12
2
.
Have SC-T46's rear panel
facing rightward.