EKOCYCLE Cube User Manual page 98

27 . Apply two thin layers of Cube Glue to the center of the print pad . Select
checkmark
the to continue .
NOTE: Apply enough glue to cover a square area of 3" (8 cm) .
NOTE: For best results, allow the glue to dry before printing .
NOTE: The printer will load the print file .
NOTE: The estimated time to completion is noted at the bottom
of the screen .
NOTE: The blue bar at the top is also a progress indicator that
shows the status of the loading process .
NOTE: The print jets will begin to heat .
CAUTION: Do not touch the print jets until they have cooled to
room temperature .
NOTE: The estimated time to completion is noted at the bottom
of the screen .
NOTE: The blue bar is a progress indicator that shows the status
of the print jet heating process .
NOTE: The blue bar is a progress indicator that illustrates the
status of the print .
NOTE: Select PAUSE
CANCEL if you wish to cancel the print job .
NOTE: Press the time at the bottom of the screen to view the
percentage of completion . Press it again to view how many
layers have been printed . After a few seconds, the default time
will appear again .
28 . Once the printer has finished printing, select the
3D Systems, Inc.
to temporarily stop printing . Select
checkmark to continue .
94